Grizzly G0501 - Manual (Page 47)

G0501 Sliding Table Saw -45-
Figure 77. Flip stop slide lock knobs.
3. Loosen the lock knobs that secure the flip
stop slide into position in the miter fence
(Figure 77).
To perform a miter cut:
1. Mount the miter fence onto the sliding table.
2. Position the fence at the desired angle and
use the clamp plate ratcheting handle to lock
the fence in place. Figure 76 shows the miter
fence set to 45˚ on the miter fence scale.
Lock Knobs
Flip Stop
Miter Fence
Figure 76. Miter fence set to 45˚ mark on the
miter fence scale.
Clamp Plate
Ratcheting Handle
Figure 78. Miter fence slide installation for cut
lengths between 9 1 ⁄
2
" and 45".
4. Position the flip stop according to the length
of the workpiece you want to cut off to the left
of the blade.
— If the desired cut-off length to the left of
the blade is between 9 1 ⁄
2
" and 45", then
the flip stop-end of the slide bar needs to
be slid into the main miter fence body first
(Figure 78).
— If the desired cut-off length to the left of
the blade is between 45" and 86 1 ⁄
2
, then
the slide bar end opposite the flip stop
needs to be slid into the main miter fence
body first (Figure 79).
Figure 79. Miter fence slide installation for cut
lengths between 45" and 86 1 ⁄
2
.