Grizzly G0501 - Manual (Page 40)

-38- G0501 Sliding Table Saw
The blades for the Model G0501 can operate at
3000, 4000, 5000, and 6000 RPM. This speed
can be easily changed by moving the V-belt posi-
tion on the main motor pulley and arbor pulley.
To change the blade speed:
1. Disconnect the saw from the power
source!
2. Remove the cap screws on the top and bot-
tom right corners, then open the motor cabi-
net door.
3. Move the belt tension handle (Figure 61)
down to loosen the V-belt.
Changing Blade
Speeds
Figure 61. Belt tension release handle.
The blade can be tilted anywhere from 0˚ to 45˚.
To change the blade tilt:
1. Turn the main power switch ON.
2. Rotate the red EMERGENCY STOP button
until it springs up.
3. Press SET on the keypad.
4. Type in your desired blade tilt. (For example:
If you want the blade to tilt to 30˚, type
3 , 0 .)
5. Press START on the keypad. The blade
should now move to your desired tilt.
Changing Blade Tilt