Grizzly G0651 - Manual (Page 28)

-26-
model g0651/g0652 (mfg. since 1/10)
7. align the table and extension table with a
straightedge, as shown in Figure 18, then
tighten all of the mounting fasteners.
6. Fasten the 79" rear rail to the extension table
with three m8-1.25 x 25 cap screws, three
8mm lock washers, six 8mm flat washers,
and three m8-1.25 hex nuts, as shown in
Figure 17. Finger tighten for now.
Figure 17. rear rail/table fastener locations.
x 3
8. install each foot with a 3 ⁄
8
-16 hex nut onto
into the bottom of a support leg, as shown in
Figure 19.
Figure 18. aligning main extension table.
Figure 19. Foot installed on support leg.
Foot
support leg
hex nut
9. Fasten each support leg to the main exten-
sion table with four m6-1 x 12 phillips head
screws and 6mm flat washers, as shown in
Figure 20.
10. rotate both feet until they touch the ground,
and tighten the hex nuts against the support
legs to secure the feet.
Figure 20. support leg fastened to main
extension table.
x 4