Grizzly G0651 - Manual (Page 45)

model g0651/g0652 (mfg. since 1/10)
-43-
To make a rip cut:
1. review preventing Kickback on page
13 and take the necessary precautions to
reduce the likelihood of kickback.
2. if using natural wood, joint one long edge of
the workpiece on a jointer.
3. disConneCt the saW From poWer!
4. ensure that the blade guard and spreader is
installed.
5. set the fence to the desired width of cut on
the scale.
6. adjust the blade height so the highest saw
tooth protrudes approximately 1 ⁄
4
" above the
workpiece.
7. set up safety devices such as featherboards
or other anti-kickback devices.
8. rotate the blade to make sure it does not
come into contact with any of the safety
devices.
9. Connect the saw to the power source, turn it
ON, and allow it to reach full speed.
"ripping" means cutting with the grain of a natu-
ral wood workpiece. in man-made materials such
as mdF or plywood, ripping simply means cutting
lengthwise.
Ripping
Serious injury can be caused by kickback.
Kickback is a high-speed expulsion of stock
from the table saw toward an operator. The
operator or bystanders may be struck by
flying stock, or the operator’s hands can be
pulled into the blade during the kickback.
Note: The jointed edge of the workpiece
must slide against the fence during the cut-
ting operation.
10. use a push stick to feed the workpiece
through the saw blade, as shown in Figure
59, until the workpiece is completely past the
saw blade.
Figure 59. typical ripping operation.
Turn OFF the saw and allow the blade to
come to a complete stop before removing
the cut-off piece. Failure to follow this warn-
ing could result in serious personal injury.
Keep the blade guard installed and in the
down position. Failure to do this could
result in serious personal injury or death.