Dust collection – Grizzly G0651 User Manual
Page 31
model g0651/g0652 (mfg. since 1/10)
-29-
28. mount the fence on the front rail to the right of
the blade.
29. install the fence resting brackets (Figure
30) onto the back of the cabinet with the two
m8-1.25 x 12 hex bolts and 8mm flat wash-
ers.
Figure 30. Fence resting brackets installed.
Brackets
x 2
30. install the miter gauge handle and 8mm flat
washer onto the miter gauge, as shown in
Figure 31.
Figure 31. miter gauge installed.
handle
Washer
31. slide the miter gauge into the t-slot on the
left side of the blade; or store it on the brack-
ets near the blade angle handwheel.
32. Follow instructions in Dust collection, power
connection, and Test Run, then proceed
to
Final Setup to complete the remaining
assembly steps.
Dust collection
DO NOT operate the Model G0651/G0652
without an adequate dust collection system.
This saw creates substantial amounts of
wood dust while operating. Failure to use a
dust collection system can result in short
and long-term respiratory injury.
Recommended cFM at Dust port: 400 cFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect a dust collection hose:
1. Fit the 4" dust hose over the dust port, as
shown in
Figure 32, and secure in place with
a hose clamp.
2. tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper
performance.
Figure 32. dust hose attached to dust port.
components and hardware Needed:
Qty
4" dust hose (not included) ...............................1
4" hose Clamp (not included) ............................2
dust Collection system (not included) ...............1