GE DECT 28821 - Manual (Page 18)

18
Message Alert
This feature sets your answering system to give an alert tone every 10 seconds when
there are new messages.
From the Answerer Menu:
1. Press the CALLER ID-VOLUME (5or 6) button to scroll to the
MESSAGE ALERT
sub-menu.
. Press mute/menu OK button to enter the menu. NEW MSG ALERT 1ON 2OFF
shows in the display.
. Use the touch-tone pad to enter the selection, or use the CALLER ID-VOLUME
(5or 6) button to scroll to the 1ON or 2OFF. The default setting is 2OFF.
. Press the mute/menu OK button to confirm. You will hear a confirmation tone and
the new setting shows in the display.
Security Code
You can access the answering system from a tone dialing telephone in another
(remote) location. The security code is required for remote access, and it prevents
unauthorized access to your answering system.
From the Answerer menu:
1. Press the CALLER ID-VOLUME (5or 6) button to scroll to the
SECURITY
CODE sub-menu.
. Press mute/menu OK button to enter the menu. SECURITY CODE 1 2 3 shows in
the display.
. Use the touch-tone pad to enter your new -digit security code. The default
setting is 123.
. Press the mute/menu OK button to confirm. You will hear a confirmation tone and
the new security code shows in the display.
NOTE: If you make a mistake, use the delete/intercom/conf button
to delete the security code and begin again.
Speaker Volume
Use the volume (5or 6) buttons to adjust speaker volume on the base to a
comfortable level. L1 is the minimum speaker volume and L5 is the maximum.