Grizzly G0514X User Manual
Page 19
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
-17-
crate contents (figure 15–17): Qty
A. Bandsaw (not shown) ................................. 1
B. table ........................................................... 1
c. Miter gauge ................................................ 1
D. standard Fence assembly ......................... 1
E. resaw Fence ............................................. 1
f. resaw Fence lock lever M8-1.25 x 45 ..... 1
G. resaw Fence t-Bar .................................... 1
h. Front square rail ........................................1
I. sliding plate.................................................1
J. table tilt handwheel ...................................1
K. guide post handwheel................................1
hardware and Tools (not shown):
Qty
•
Bandsaw Blade 6 tpi hook 143" ................1
•
eye Bolt M10-1.5 (may be installed) ............1
•
Flat Washers 8mm
(table, sliding plate, Fence) .......................8
•
lock Washers 8mm (table) ........................4
•
hex Bolts M8-1.25 x 25 (table) ...................4
•
hex Bolt M8-1.25 x 55 (sliding plate) ..........1
•
lock nut M8-1.25 (sliding plate) .................1
•
Cap screws M6-1 x 12 (sliding plate) .........2
•
hex Bolt M8-1.25 x 90 (pos. stop) ..............1
•
hex nuts M8-1.25 (pos. stop, Fence) .........2
•
table pin......................................................1
•
table insert ..................................................1
•
Cap screws M6-1 x 16 (Fence) ...................2
•
hex Bolts M6-1 x 20 (Fence) .......................2
•
Fence handle M8-1.25 x 22 (Fence) ...........1
•
rail pad M6 x 18 (Fence) ............................1
•
hex nut M6-1 (Fence) .................................1
•
lock handle M8-1.25 x 44 (Fence) .............1
•
Moving plate (Fence)...................................1
•
lock Washers 6mm (Fence, sliding plate) .4
•
Flat Washers 6mm (Fence, sliding plate) ...4
•
hex Wrench 5mm & 8mm ..................... 1 ea
•
open end Wrench 10 x 13mm ....................1
G0514X2B
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
d
figure 16. Fence components.
d
e
F
g
h
figure 17. Foot brake and table tilt components.
i
j
K
figure 15. Bandsaw components.
B
C