Grizzly G0514X - Manual (Page 32)

-30-
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following: 1)
the motor powers up and runs correctly, 2) the
safety disabling mechanism on the switch works
correctly, and 3) the stop button safety feature
works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on page 55.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. turn the machine ON to verify that it is oper-
ating correctly by turning the switch disabling
key (
figure 48) to "1" .
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
4. press the oFF button to stop the machine.
5. Without resetting the oFF button, press
the on button. the machine should not
start.
—if the machine does not start, the oFF but-
ton safety feature is working correctly.
—if the machine does start (with the stop
button pushed in), immediately disconnect
power to the machine. the oFF button
safety feature is not working correctly. this
safety feature must work properly before
proceeding with regular operations. Call
tech support for help.
6. push the oFF button in, then twist it clock-
wise so it pops out. When the oFF button
pops out, the switch is reset and ready for
operation (see
figure 49).
OFF Button
TWIST
figure 49. resetting the switch.
figure 48. switch disabling key and on/oFF
switch.
switch
disabling
Key