Grizzly G0514X - Manual (Page 56)

-54-
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
Table Tilt Rack and pinion Assembly
(G0514X2, G0514X2B, & G0514X3)
Lubricant frequency Qty
Multi-purpose
gl2 grease as needed thin Coat
Trunnion
Lubricant frequency Qty
Multi-purpose
gl2 grease as needed thin Coat
To lubricate the table tilt rack and pinion
assembly:
1. disConneCt BandsaW FroM poWer!
2. With the table perpendicular to the blade, and
using a rag and mineral spirits, wipe off all
existing grease and sawdust buildup from the
rack.
3. Move the table up to its maximum 45˚ angle
and wipe ( figure 93) off all existing grease
and sawdust buildup from the rack.
figure 93. example of lubricating table tilt rack
and pinion assembly.
4. apply a thin coat of multipurpose grease to
the rack.
5. Move the table up and down several times
to distribute the grease, then wipe off any
excess grease.
To lubricate the trunnion, do these steps:
1. disConneCt BandsaW FroM poWer!
2. Move the table up until it reaches its maxi-
mum 45˚ angle, and using a rag and mineral
spirits, wipe off all excess grease and saw-
dust from the trunnion.
3. apply a thin coat of light all purpose grease to
the outside surfaces of the trunnion ( figure
94 & 95).
4. Move the table down and then back up to dis-
tribute the grease, then wipe off any excess
grease from the trunnion.
figure 95. trunnion lubrication location
(g0514X2/g0514X2B/g0514X3).
figure 94. trunnion lubrication location
(g0514X).