Grizzly G0514X - Manual (Page 23)

G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
-21-
We recommend mounting your new machine to
the floor. Because floor materials may vary, floor
mounting hardware is not included. you may also
mount your machine to a mobile base that has
wheel locking or wheel retracting capabilities that
keeps the mobile base from rolling when not in
use.
Bolting to concrete floors
lag shield anchors with lag bolts ( figure 21) and
anchor studs ( figure 22) are two popular meth-
ods for anchoring an object to a concrete floor.
We suggest you research the many options and
methods for mounting your machine and choose
the best that fits your specific application.
Mounting
figure 21. typical lag shield anchor and bolt.
figure 22. typical anchor stud.
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
which may cause a tripping hazard if you
decide to move your machine.
Assembly
Guide post handwheel
secure the guide post handwheel onto the
handwheel shaft flat with the included set screw
(see
figure 23).
figure 23. guide post handwheel installed.
guide post
handwheel
Table
the table is heavy and requires two people to lift
it onto the trunnions. remove the saw blade to
make table installation easier.
To install the table:
1. loosen blade tension by rotating the quick
release tension lever clockwise, as shown in
figure 24.
figure 24. Quick release tension lever.
tighten loosen