GE IM4A - Manual (Page 10)

10
2
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS L
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator —
or S R Q P N M L
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION –
Unplug the
Refrigerator. To eliminate the danger of
electric shock during installation, you
must unplug the refrigerator from its
electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1 REMOVE ICE CUBE TRAY SHELF
• Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
• Replace the screws but do not screw them all the
way in. The screw heads should extend about
1/2
″ (13 mm) from the side wall of the freezer.
1/4
″ Nutdriver or adjustable wrench
Remove
plug
INSTALL FILL TUBE EXTENSION
• Cut the fill tube extension (8)
to the length (refer to the
template on page 42) with a
sharp knife or a single-edge razor
blade and slide it onto the fill tube
against the stop.
L
L
3
PREPARE FOR INSTALLATION
• Remove and discard the large white plug from
the rear freezer wall.
• Remove the outlet cover with a flat-blade
screwdriver.
L
8