GE IM4A - Manual (Page 19)

19
Installation Instructions
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until
the refrigerator is connected to the water
supply to prevent premature operation.
4
Power
Switch
INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted) (15)
into the icemaker as shown.
5
15
PLUG IN THE ICEMAKER
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the rear wall,
making sure the prongs and holes are matched. Press
the plug firmly into the socket. Lock the plug in place
by clipping the restraints onto each side of the plug.
Make sure the restraints click into place. Make sure
the power cord is still in the hook on the back of
the icemaker.
6
MOUNT THE ICEMAKER
• Lift the icemaker so the fill tube (14) goes into
the fill cup opening (15). Hang the icemaker
on the two mounting screws (11).
Make sure:
• The power cord is still firmly in the socket.
• The fill tube (14) extends into the fill cup opening
at the back of the icemaker. (Check the rear of
the refrigerator to make sure the fill tube has not
been pushed out of the back of the refrigerator).
• The icemaker mounting screws are located in
the uppermost position of the mounting slots.
• The icemaker is level.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
7
14
15
INSTALL THE ICE BUCKET
Place the ice bucket (9) under the icemaker.
Make sure the icemaker power switch is set to OFF.
8
9
ATTACH WARRANTY LABEL
A label (7) is provided with this kit to record the date
of installation for warranty purposes. Apply it to
the back of the refrigerator.
9
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner’s Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
10
11
Hook
(Appearance may vary)