GE IM4A - Manual (Page 7)

7
BEFORE YOU BEGIN
Installation IM-4A
Instructions Icemaker Kit
Read these instructions completely and carefully.
•
IMPORTANT –
Save these instructions
for local inspector’s use.
•
IMPORTANT –
Observe all governing
codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these instructions
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical and electrical skills.
• Completion time – 20–60 minutes
• Proper installation is the responsibility
of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
It’s important that you use the water valve and fill tube
extension that come with this kit, even though your
refrigerator may already have them installed.
The old valve will not allow enough water through
to fill the icemaker properly and will cause damage.
The fill tube extension needs to be a different length
than the original tube for proper water flow. Cut the tube
to the length indicated for your model of refrigerator.
ARE YOU REPLACING AN
ICEMAKER WITH THIS KIT?
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at:
ge.com
In Canada, call 1.800.561.3344 or Visit our Website at:
geappliances.ca
There is a label on the back of the refrigerator
that will tell you whether to use Instructions:
or
Pages 10–37 contain seven different Installation
Instructions.
The actual installation of the icemaker will depend
on which model refrigerator you have.
S R Q P N M L
WHICH INSTRUCTIONS SHOULD YOU
FOLLOW?
• If the unit is damaged in shipment, return the unit
to the store in which it was bought for repair or
replacement.
• If the unit is damaged by the customer, repair or
replacement is the responsibility of the customer.
• If the unit is damaged by the installer (if other than
the customer), repair or replacement must be made
by arrangement between customer and installer.
DAMAGE – SHIPMENT/INSTALLATION