GE IM4A - Manual (Page 26)

26
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS Q
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator —
or S R Q P N M L
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION –
Unplug
the Refrigerator. To eliminate
the danger of electric shock during
installation, you must unplug
the refrigerator from its electrical
outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF.
Leave the power switch in the OFF position until
the refrigerator is connected to the water supply
to prevent premature operation.
3
Power
Switch
INSTALL FILL TUBE
• Cut the fill tube (13) to
the length (refer to the
template on page 42) with a
sharp knife or a single-edge
razor blade.
• Slide the fill tube (13) onto the water tube inlet (12).
• Go to the back of the refrigerator. In the upper
right hand corner, remove the label covering the hole.
Pull out the insulation plug and any debris. (It may be
necessary to remove the screw from the top right
condenser mounting clip for better access to
the hole.)
• On the tube side of
the water tube inlet (12),
there is an adhesive backing.
Remove the adhesive backing
and slide the tube into
the hole near the top
at the back of the refrigerator. Firmly press
on the inlet to secure it to the refrigerator.
Q Q
2
12
13
PREPARE FOR INSTALLATION
• Remove and discard the large white plug or foil
sticker from the rear freezer wall. Pull out the
gray insulation plug and remove any debris.
• Loosen the two mounting screws but do not
screw them all the way out. The screws should
extend approximately 1/2
″ (13 mm) out from
the freezer wall.
• Remove the outlet cover with a flat-blade
screwdriver.
1
(Appearance may vary)