Grizzly Jointer/ G0634Z - Manual

Copyright © september, 2009 by grizzly industrial, inC.
Warning: no portion of this manual may be reproduced in any shape
or form Without the Written approval of grizzly industrial, inc.
(For models manuFaCtured sinCe 5/09) #bl12040 printed in taiwan
the model g0634z is the same machine as the model g0634 except it has a different type of spiral
cutterhead. except for the differences noted in this insert, all other content in the model g0633/g0634
owner's manual applies to this machine. before operating your new machine, you must read and under-
stand this insert and the entire model g0633/g0634 manual to reduce the risk of injury when using this
machine.
If you have any further questions about this manual insert or the differences between the Model G0634Z
and the Model G0633/G0634, contact our Technical Support at (570) 546-9663 or email techsupport@
grizzly.com.
model g0634z
Jointer/planer
combination machine W/
spiral cutterhead
manual insert
machine inventory
refer to the inventory in the g0633/g0634
manual on page 14. after all the parts have been
removed from the crate, you should have the fol-
lowing items:
common components (figure 1) Qty
a. Jointer/planer assembly (not shown) ........ 1
b. push blocks ................................................ 2
c. Cutterhead guard assembly ...................... 1
d. hardware and tools (not shown)
— wrench 12/14mm ................................... 1
— hex wrench 3mm .................................. 1
figure 1. Common components.
b
C
figure 2. spiral cutterhead hardware.
g
g0634z only (figure 2 )
g. spiral Cutterhead hardware
—indexable Carbide inserts....................... 5
—Flat head torx screws 10-32 x
1 ⁄
2
" ....... 10
—torx drivers t25 ..................................... 5
—t-handle wrench
1 /
4
" .............................. 1