Grizzly Jointer/ G0634Z - Manual (Page 38)

-20-
G0633/G0634 Jointer/Planer Combo Machine
Test Run
Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation. The test run consists
of verifying the following: 1) The motor powers up
and runs smoothly and without vibration and 2)
the stop button safety feature works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration,
stop using the machine immediately, then review
Troubleshooting on Page 37.
If you cannot find a remedy, contact our Tech
Support at (570) 546-9663 for assistance.
6. Verify that the machine is operating correctly
by pushing the green ON button.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
7. Press the EMERGENCY OFF button to stop
the machine.
8. WITHOUT resetting the switch, press the ON
button. The machine should not start.
—If the machine does not start, the
EMERGENCY OFF button safety feature
is working correctly.
—If the machine does start (with the
EMERGENCY OFF button pushed in),
immediately disconnect power to the
machine. The EMERGENCY OFF button
safety feature is not working correctly. This
safety feature must work properly before
proceeding with regular operations. Call
Tech Support for help.
9. Press the ON button, then immediately press
the OFF button on the magnetic box ( Figure
1, Page 7).
—If the machine turns off, the OFF button is
working correctly. The Test Run is com-
plete.
—If the machine does not stop, disconnect
power to the machine. The OFF button
is not working correctly. This feature must
work properly before proceeding with regu-
lar operations. Call Tech Support for help.
Before starting the jointer/planer, make sure
you have performed the preceding assem-
bly and adjustment instructions, and you
have read through the rest of the manual
and are familiar with the various functions
and safety features on this machine. Failure
to follow this warning could result in seri-
ous personal injury or even death!
To test run the machine:
1. Make sure you understand the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Make sure the jointer tables are folded down
and locked in place (see Page 25).
4. Connect the machine to the power source.
5. Push the EMERGENCY OFF button in, then
twist it clockwise so it pops out. See Figure
1, Page 7 for location of the EMERGENCY
OFF button. When the OFF button pops out,
the switch is reset and ready for operation
(see
Figure 17).
���
�����
������������
����������
��������
���������
Figure 17. Resetting the Emergency Off switch.