Grizzly Jointer/ G0634Z - Manual (Page 43)

G0633/G0634 Jointer/Planer Combo Machine
-25-
5. Turn the table lock lever (Figure 24) clock-
wise, pull it out, and turn the table up. The
table will lock into place when raised to its
highest position as shown in
Figure 25.
Figure 24. Infeed table lock lever.
6. Raise the outfeed table in the same manner
as you did with the infeed table.
7. Swing the planer dust port clockwise over the
cutterhead as shown in Figure 26.
Table Lock
Lever
Figure 26. Planer dust port setup.
Planer Dust
Port
8. Connect the dust hose to the planer dust
port.
9. Flip the change lever (Figure 22) up.
To change the machine for jointer opera-
tions:
1. Lower the planer table to below the 4" mark
on the table height scale.
2. Reverse Steps 2-9 in the previous subsec-
tion. Pull up on the table lock knobs to lower
the table. Make sure you lower the planer
dust port to the "down" position (as shown in
Figure 27).
Figure 27. Planer dust port in "down" position.
Serious personal injury could occur if you
place your fingers between the tables and
base or between pivot points. Your hands
could be pinched or crushed!
Figure 25. Infeed table in "up" position.
Planer Dust Port