Squaring stock – Grizzly Jointer/ G0634Z User Manual

Page 45

Advertising
background image

G0633/G0634 Jointer/Planer Combo Machine

-27-

��

��

��

Squaring stock involves four steps performed

in the order below:

1. Surface Plane on the Jointer—The con-

cave face of the workpiece is surface planed
flat with a jointer.

Previously

Jointed Edge

Previously

Surface

Planed Face

2. Surface Plane on the Thickness Planer

The opposite face of the workpiece is surface
planed flat with a thickness planer.

3. Edge Joint on the Jointer—The concave

edge of the workpiece is jointed flat with a
jointer.

4. Rip Cut on a Table Saw—The jointed edge

of the workpiece is placed against a table
saw fence and the opposite edge cut off.

Squaring Stock

Figure 30. Minimum dimensions for edge jointing

and surface planing (jointer).

1

2

" Min.

1" Min.

12" Min.

12" Min.

1

2

" Min.

1" Min.

Thickness Planer Specific Rules:

Use the full width of the planer. Alternate
between the left, the right, and the middle
when feeding narrower lumber into the plan-
er. Your knives/inserts will remain sharp
much longer.

Figure 31. Minimum dimensions for surface

planing (thickness planer).

1

4

" Min.

1" Min.

12" Min.

Advertising