Grizzly Jointer/ G0634Z - Manual (Page 32)

-14-
G0633/G0634 Jointer/Planer Combo Machine
Inventory
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 5. Spiral cutterhead hardware.
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
Note: If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully. Occasionally
we pre-install certain components for shipping
purposes.
Common Components (Figure 3 & 3) Qty
A. Jointer/Planer Assembly (Not shown) ........ 1
B. Push Blocks ................................................ 2
C. Cutterhead Guard Assembly ...................... 1
D. Hardware and Tools (Not Shown)
— Wrench 12/14 ......................................... 1
— Hex Wrench 3mm .................................. 1
G0633 ONLY (Figure 4)
E. Knife Setting Jig Hardware
— Knife Setting Gauge Feet ...................... 2
— Knife Setting Gauge Rod ....................... 1
— E-Clips 9mm .......................................... 2
F. Tools (Not Shown)
— Wrench 8/10mm .................................... 1
G0634 ONLY (Figure 5)
G. Spiral Cutterhead Hardware
— Indexable Carbide Inserts ..................... 5
— Flat Head Torx Screws M6-1 x 15 ........ 10
—Torx Drivers T20 ..................................... 5
—T-Handle Wrench
1 /
4
" .............................. 1
Figure 3. Common components.
B
C
Figure 4. Knife gauge hardware.
E
G