GE 800-EFM - Manual (Page 10)

Step 3: Connect Power Cord
Installing Your External Paging Adapter
1 Connect Power Cord to Module
Plug the AC power cord into the adapter jack at
the rear of the Feature Module. Thread the
power cord around the strain relief tab.
2 Connect Power Cord to Wall Outlet
Plug the AC adapter into an electrical outlet not
controlled by a wall switch.
3 Make Sure that Status Indicator lamp
is Blinking
This indicates that the feature module is prop-
erly connected to electrical power.
The blinking pattern for the External Paging
Adapter is two blinks every few seconds.
4
800-EFM guide for PDF v1 091102.qxd 9/11/2002 2:40 PM Page 11