GE 800-EFM - Manual (Page 8)

Step 1: Connect Line Cord
1 Connect Line Cord
Connect one end of a long telephone line cord
to the jack on the back of the feature module
labeled L1/L2. Connect the other end to a jack
labeled Lines 1 & 2 or to a jack labeled line 1.
PLEASE NOTE: You must be sure to
connect the cord to LINE 1. It does
not matter if it is also connected to
line 2.
Note also that you can install your feature mod-
ule into a jack that is already being used by
another device. Simply unplug the other
device from the wall jack and plug it into the
corresponding jack on the feature module
labeled “TO PHONE.” Then connect a line cord
from the wall jack to the corresponding jack on
the feature module labeled “TO WALL.”
IMPORTANT NOTE: If you connect both the
L1/L2 and L3/L4 line cords from a device to the
jacks on the module labeled “TO PHONE,”
then you MUST connect both the L1/L2 and the
L3/L4 line cords from the wall jacks to the jacks
on the module labeled “TO WALL.”
2
Installing Your External Paging Adapter
L1/L2
Lines
1&2
L1/L2 L3/L4
Lines
1&2
Lines
3&4
If you wish to plug in the module to a jack
that is already in use, unplug the existing
device from the wall jacks, connect both of
the line cords to the module as shown,
and then plug the device into the jacks on
the module labeled “TO PHONE.”
800-EFM guide for PDF v1 091102.qxd 9/11/2002 2:40 PM Page 9