Grizzly G0695 - Manual (Page 38)

-36-
model g0695 (mfg. since 9/10)
NOTICE
failure to follow the lubrication practices
outlined in this manual could lead to pre-
mature failure of your mill and void the war-
ranty.
One-Shot Oiler
Lubricant frequency Qty
iso 68 Lubricant or
Equivalent Every
8 hours
of operation 1
pump
the oil lines running from the one-shot oiler feed
lubrication to the ways of the column (knee),
saddle, and table.
Use the sight glass on the front of the oiler to make
sure it is full, then pull the handle (see
figure 54)
and release it to send lubricant through the lines.
figure 54. one-shot oiler.
oil Line
one-shot
pump
handle
Fill Cap
Quill Gearing
Lubricant frequency Qty
iso 68 Lubricant or
Equivalent Every
8 hours
of operation 5
drops
Lift the cap of the oil cup shown in figure 55 to
add the lubricant.
figure 55. Quill gearing oil cup.
Vertical bevel Gears
Lubricant frequency Qty
nLgi #2 grease Every
40 hours
of operation thin
Coat
raise the knee up to access the vertical bevel
gears underneath the saddle, then clean and
lubricate the bevel gears shown in
figure 56.
figure 56. Vertical bevel gears.
Bevel gears
Quill gearing
oil Cup