Grizzly G0695 - Manual (Page 44)

-42-
model g0695 (mfg. since 9/10)
figure 66. Belt cover removal.
5. Using a 17mm wrench, loosen the lock bolt,
use the belt tension lever to de-tension the
belt, then remove the belt.
6. install a new belt.
figure 67. V-belt tension lever.
Lock Bolt
& Belt
tension
Lever
8. re-install the belt cover, the belt access
plate, and return the headstock to the vertical
position.
7. push firmly and hold the belt tension lever
toward the rear of the machine and re-tighten
the lock bolt (
figure 67). no belt deflection is
required.
4. Using a 5mm hex wrench, remove the belt
cover by pulling the four cap screws ( figure
66).
Belt Cover