Recommended adjustments, Test run – Grizzly G0613/G0614 User Manual

Page 21

Advertising
background image

G0613/14 Swivel Mast Metal Cutting Bandsaw

-19-

The adjustments listed below have been per-
formed at the factory. However, because of the
many variables involved with shipping, we recom-
mend that you verify the following adjustments
before the

Test Run and to ensure cutting results

meet your standards.

Step-by-step instructions on verifying these adjust-
ments can be found in

SECTION 7: SERVICE

ADJUSTMENTS.

Factory adjustments that should be verified:

1. Blade Tension (Page 33).

2. G0613 Blade Guide Adjustment (Page 34).

3. G0614 Blade Guide Adjustment (Page 36).

4. Stop Adjustments (Page 38).

5. Blade Squaring Adjustment (Page 40).

Recommended

Adjustments

Starting the machine:

1. Read the entire instruction manual.

2. Make sure all tools and foreign objects have

been removed from the machine.

3. Make sure that you verify the Recommended

Adjustments listed on this page.

4. Fill the cutting fluid reservoir with cutting

fluid if not done so already, DO NOT run the
pump without cutting fluid or you will damage
the pump.

5. Put on safety glasses and secure loose

clothing or long hair.

6. Connect the bandsaw to power.

7. Raise the bandsaw and close the feed rate

control knob to keep the saw in place.

8. Start the bandsaw while keeping your finger

near the EMERGENCY STOP/OFF button
at all times during the test run. The bandsaw
should run smoothly with little or no vibra-
tion.

Note: If the EMERGENCY STOP/OFF but-
ton is pressed, it needs to be twisted until it
pops out or the bandsaw will not start
.

— If you hear or see any problems, immedi-

ately stop the bandsaw and correct before
continuing.

—If you need any help with your bandsaw

call our Tech Support at (570) 546-9663.

Projectiles thrown from

the machine could cause

serious eye injury. Wear

safety glasses during

assembly and operation.

Test Run

Advertising