Grizzly G0613/G0614 - Manual (Page 23)

G0613/14 Swivel Mast Metal Cutting Bandsaw
-21-
Workstop
Your bandsaw has an adjustable workstop ( Figure
14) that is easy to install and to use.
To install the workstop:
1. Thread the workstop rod in the base and
tighten the jam nut.
2. Slide the workstop onto the rod.
The vise has a quick tighten/release lever and,
depending on the cut angle or workpiece shape,
you can remove or install the aluminium vise
clamp plate (
Figure 16) for additional holding
force.
Vise
Figure 16. Vise options and controls.
To use the vise:
1. Raise the bow and lock it in place by closing
the feed ON/OFF valve ( Figure 15).
Vise Lock Lever
Handwheel
Steel Plate
Figure 14. Workstop assembly.
3. Measure the distance from the blade to the
workstop, slide workstop to the needed posi-
tion and tighten the lock lever.
Workstop Rod
Workstop
Lock
Lever
Jam Nut Figure 15. Feed ON/OFF Valve.
Feed ON/OFF
2. Insert the workpiece between the jaws.
3. Use the handwheel (Figure 16) to move the
jaws so they are within 1/8" from clamping
the workpiece.
4. Use the vise lock lever to hold the workpiece
and quickly release the jaws to move the
workpiece after a cut.