Grizzly G0493 - Manual (Page 26)

-24-
Model g0493 (Mfg. since 7/10)
moving & placing
base unit
to remove the saw base unit from the crate
pallet:
1. remove the top of the crate and position the
forklift forks together and directly above the
saw.
2. place two lifting straps over the forks and
attach the ends to the lifting bolts as shown
in
figure 19.
figure 19. lifting the saw base unit.
3. lift the saw base unit and move it to your
predetermined location.
4. Before lowering the saw into position, place
safety blocks under the frame and thread the
four feet into the frame at least half of the
length.
5. remove the safety blocks and lower the saw
onto the feet as shown in figure 20 and
remove the forklift straps.
figure 20. Foot installed in cabinet leg.
6. place a level on the saw table and adjust the
feet so the saw table is level from left-to-right
and from front-to-back. this will allow the
table to slide smoothly.
7. lock the feet in position by tightening the two
hex nuts together against the cabinet leg.
use lifting straps with a minimum of 1500
lbs. lifting capacity. if the lifting strap breaks,
serious personal injury may occur.
this machine and its
components are heavy.
serious injury may occur
if safe moving methods
are not followed.
get help when lifting or
moving the machine and
its components. use a
forklift to reduce the
risk of a lifting strain or
crushing injury.
do not lift the table saw any higher than
necessary to clear the floor. serious per-
sonal injury and damage to the machine
may occur if safe moving methods are not
followed.