Grizzly G0493 - Manual (Page 27)

Model g0493 (Mfg. since 7/10)
-25-
assembly & setup
Before shipping, the sliding table was set at the
factory to be even with the main table and parallel
with the blade.
the sliding table and extension tables are heavy
so you must get help lifting them during the
installation process. We recommend having four
strong helpers lift the sliding table and having an
additional person help position the t-bolts into the
holes when the table is lowered.
to assemble the sliding table saw:
1. remove the red shipping brace (figure 21)
and the screws indicated. set the screws
aside for use in the following steps.
figure 22. sliding table upside down.
4. install the two locating blocks with the four
M6-1 x 16 flat head screws.
5. install the lock rod with the six M6-1 x 35 cap
screws and six 6mm lock washers, as shown
in
figure 24.
figure 24. locating blocks and lock rod installed
on sliding table.
figure 23. t-bolts inserted into table track.
6. lift the sliding table up and fit the t-bolts into
the mounting holes on the cabinet. (an addi-
tional person may need to adjust the t-bolt
spacing to allow the sliding table to fit.)
3. insert the three t-bolts into the track along
the bottom of the sliding table base ( figure
23), and space them apart the same distance
as the mounting holes in the cabinet.
figure 21. sliding table.
red shipping
Brace
2. turn the sliding table upside down, as shown
in figure 22.
t-Bolt
Mounting hole
lock
rod
locating Block