Grizzly G0493 - Manual (Page 35)

Model g0493 (Mfg. since 7/10)
-33-
figure 53. installing the crosscut table.
48. With the help of an assistant, place the cross-
cut table on the pivot pin of the swing arm
and slide the t-nut into the t-slot in the slid-
ing table (see
figure 53).
49. slide two M8-1.25 t-nuts into the crosscut
table brace. align the t-nuts in the crosscut
table brace with the holes in the crosscut
table, and thread the two M8-1.25 x 50
knobs, with two 8mm flat washers, into the
t-nuts as shown in
figure 54.
Crosscut
table Brace
figure 54. installing the crosscut table brace.
sliding t-nut
into t-slot
50. install the components shown in figure 55
on the crosscut fence.
figure 55. Crosscut fence assembly.
t-nut, Fiber Washer & Center stud
t-Bolt
M8-1.25 X 25
KnoB
Flip stops
51. position the center stud and the t-bolt over
the placement holes shown in figure 56,
then tighten the center stud.
figure 56. Crosscut fence placement.
Center stud
placement
t-Bolt
placement
52. thread the M8-1.25 knob with an 8mm flat
washer onto the t-bolt to secure the crosscut
fence.
53. slide the blade guard/dust hood over the
riving knife, and attach it with an M8-1.25 x
40 button head cap screw and an 8mm flat
washer.
54. (optional) if needed, slide the edge shoe and
hold down clamp into the table t-slot, and
tighten the respective knob/handle. position
where necessary. (the front cover picture
shows these items installed.)
t-nut, Block,
lock Washer,
Cap screw