Grizzly G0493 - Manual (Page 37)

Model g0493 (Mfg. since 7/10)
-35-
test run
after the machine has been connected to the
power source, it Must be test run to make sure
all the controls are working properly.
the test run includes verifying that the safety
disabling components on the machine work cor-
rectly.
Before beginning the test run, review the controls
shown in
figures 62–63.
figure 62. Main power controls.
Blade on Buttons
Blade oFF Buttons
#1 emergency
stop switch
power switch
#2 emergency stop switch
figure 63. emergency stop switch #2.
power light
Before the machine can be connected to the
power source, an electrical circuit and connec-
tion device must be prepared per the
POWER
SUPPLY section in this manual; and all previous
setup instructions in this manual must be com-
plete to ensure that the machine has been assem-
bled and installed properly. The disconnect switch
installed by the electrician (as recommended) is
the primary means for disconnecting or connect-
ing the machine to the power source.
power connection
figure 60. Connecting power to machine.
Move the disconnect switch handle to the ON
position, as illustrated below. The machine is now
connected to the power source.
connecting to power source
figure 61. disconnecting power from machine.
Move the disconnect switch handle to the OFF
position, as illustrated below. The machine is now
disconnected from the power source.
Note: Lock the switch in the OFF position to
restrict others from starting the machine.
disconnecting from power source