GE 21008 - Manual (Page 15)

15
1. Press the MUTE/program button to go to SET TONE/PULSE menu.
2. The default dialing mode is set to TONE.
3. Use the touch-tone pad to select 1 for TONE dialing or 2 for PULSE
dialing, or use the cid/vol (up and down arrow) button to scroll to
1TONE or 2PULSE dialing.
4. Press the MUTE/program button to save your selection. You will hear a
confirmation tone.
NOTE: Press the EXIT button once to keep the previous setting and return to
the standby screen.
If you aren't sure which dialing system you have, set the telephone to tone
dialing and make a test call. If the call connects, the setting is correct. If the
call does not connect, set the telephone to pulse dialing.
R
EGISTRATION
This setting may be made with the handsets only. Your dual handsets are
pre-registered and ready to use. It is not recommended that handset be
registered again unless absolutely necessary.
1. If necessary, press the MUTE/program button to go to the
REGISTRATION menu. The default is 2 NO.
2. Use the touch-tone pad to select 1 for YES or 2 for NO. Or use the cid/
vol (up and down arrow) button to scroll to 1 YES or 2 NO.
3. If you select 1 YES, press the MUTE/program button to confirm your
selection. HOLD BASE PAGE WAIT FOR BEEP shows in the display.
4. Press and hold the page button on the base unit until you hear a long
tone at the handset. HANDSET X REGISTERED shows in the handset
display, where X is the handset name. You will hear a confirmation tone.
NOTE: Press the EXIT button once to keep the previous setting and return to the
standby screen. Or press and hold the EXIT button to return to standby mode.
NOTE: After you register a unit, HANDSET NAME menu automatically shows
in the display and prompts you to enter the handset name. For more
information, please refer to HANDSET NAME section of this manual.