MicroBoards Technology CD Disc-to-Disc Office Copier II - Manual (Page 21)

Orbit II Disc-to-Disc Copier Reference Manual – Revision I
21
Unloading Masters:
When the Input Hopper is empty, Orbit II will alert you by sounding the Buzzer, and scrolling an Input
Hopper Empty message on the Display.
• If your job is not completed, load the appropriate number of discs into the Input Hopper, and press
the Yes key to continue your job.
• If your job is done, press the No key again. Orbit II will open the Reader Tray so you can
unload your master.
• If you are not going to do another job, unload your master and gently push the Reader tray inward
until it powers itself closed.
• If you are going to start a different job, replace the master in the Reader tray, insert the desired
quantity of discs in the Input Hopper, select the desired Orbit II operation, and press the Yes
key again to close the Reader tray and start the new job.
We suggest you keep the master disc on top of your stack of copies. This will identify the stack of
discs, and keep your master available for compare operations or quality assurance tests.