MicroBoards Technology CD Disc-to-Disc Office Copier II - Manual (Page 4)

Orbit II Disc-to-Disc Copier Reference Manual – Revision I
4
Section 2 Setting Up your CD-R Copying Area:
A clean and orderly work place is required to consistently produce high quality copies. We suggest you
locate your Orbit II Stand Alone CD-to-CD Office Copier in an office like environment free of dust and
debris. Any contamination that gets on the CDs, CD-Rs, or CD-RWs you use as masters or blanks can
cause rejects that will reduce your yield and increase your cost. Even worse than yield loss is the
possibility that a CD-R you duplicate will not work in your customer’s CD Drive. Dust and debris will also
increase Orbit II system maintenance, and possibly shorten the service life of your Orbit II CD-to-CD Office
Copier
After you have selected a clean working environment for your Orbit II, you should allow enough tabletop
space around the unit to properly organize the flow of masters, blank media, duplicated discs, and process
rejects. In the example photograph below, workflow is from right to left. Blank discs waiting for copying are
on the right of the Orbit II, along with a clearly labeled container for rejects. Completed copy jobs and
masters are to the left of the Orbit II. Remember; it is sometimes difficult to tell if an unlabeled CD-R has
been duplicated. It is virtually impossible to identify the content of a duplicated CD-R until it is labeled or
printed. An organized workspace is the key to controlling the quality and consistency of your CD-R copy
process.
Temperature in your CD-R copy area should be between 65 and 85 degrees F. (18 – 29 degrees C.)
Humidity should be maintained between 30 and 80 % RH, if possible. CD-R copying can be performed
outside these recommended limits, but operator comfort and process yield may be affected.
In our sample CD-R copying Setup above we are keeping each completed copying job on a separate
spindle, with the master disc on top of the stack. This keeps the master available for quality control
“compare” tests. The master also clearly identifies the contents of each stack.