MicroBoards Technology CD Disc-to-Disc Office Copier II - Manual (Page 22)

Orbit II Disc-to-Disc Copier Reference Manual – Revision I
22
5.7 CD-R Handling Tests:
These tests will verify that your new Orbit II has not suffered any shipping damage that affects CD-R
handling.
Accepted Disc Test:
• Load approximately 10 blank CD-R discs in the Input Hopper. (Remember; Burn CD? has
been turned off. The discs you use for this test will not be recorded.)
• Press the Yes key at the prompt.
• When the
prompt appears, press No to set the “10s” digit
to “1”, and press Yes to accept the “10s” digit setting. The underline cursor will move to the
“1s” digit. Press the Yes key to accept the “0” setting and tell Orbit II you want a ten disc
job.
Copy CD-to-CD?
Quantity? 00
• When the CD Reader tray opens, place a short master (you can use the Orbit II distribution disc)
in the CD Reader tray and press Yes .
• Orbit II will perform a simulated copy operation on the 10 discs and place them in the Accept
Basket.
•
If all of the discs are placed in the Accept Basket, this test has been completed successfully.
Proceed to the Rejected Disc Test. If you experienced CD-R handling problems in this test,
contact Microboards Technology Technical Support for assistance.
Rejected Disc Test:
•
Load approximately 10 blank CD-R discs in the Input Hopper.
• Press the No key at the and
prompts.
Copy CD-to-CD? Copy & Compare?
• Press the Yes key at the
prompt.
• When the
prompt appears, press No to set the “10s” digit
to “1”, and press Yes to accept the “10s” digit setting. The underline cursor will move to the
“1s” digit. Press the Yes key to accept the “0” setting and tell Orbit II you want a ten disc
job.
Quantity? 00
Compare CD?
• When the CD Reader tray opens, place a short master (you can use the Orbit II distribution disc)
in the CD Reader tray and press Yes .
• Orbit II will perform a compare operation on the 10 discs. Because they are blank it will place
them on the Reject side of the Orbit 2.
•
If all of the discs are placed on the Reject side, this test has been completed successfully.
Proceed to the Writer and Reader Tests that follow. If you experienced CD-R handling problems
in this test, contact Microboards Technology Technical Support for assistance.