Philips Magnavox CT270MW8 A - Manual (Page 15)

15
EN
W
ATCHING TV
WATCHING TV
OPERATING VCR
OPERATING DVD
INTRODUCTION
PREPARATION
INITIAL SETTING
DVD SETTING
INFORMATION
TROUBLESHOOTING
ESPAÑOL
Channel Selection
Select channels by pressing [CH. K / L] or [the Number buttons].
• To select the memorized channels, use [CH. K / L] or
[the Number buttons].
• To select the non-memorized channels,
use [the Number buttons].
To Use [the Number buttons]
TV
- When selecting analog channel 12
DTV
- When selecting digital channel 12-1
• When you select a channel larger than 100,
press [+10/+100] first.
Then use [the Number buttons] to press the lower
2-digit numbers.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital broad-
casting offers a service that enables multiple signals to
send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
CH4
CH4
(high definition TV)
18:00
18:30
19:00
19:30
20:00
20:30
CH4-1
CH4
CH4
No signal
No signal No signal
CH4-2
ATSC (digital mode)
CH4
NTSC (analog mode) [Air Time]
No signal
CH4-1 CH4 CH4-2
: change automatically
major channel minor channel
: change manually by using [CH. / ]
Although, you cannot watch the high definition TV
(HDTV) program, the unit converts the HDTV signal
down to the standard definition TV signal.
Note:
• “NO SIGNAL” will appear on the TV screen after the minor
channel broadcast is over.
5 Volume Adjustment
This section describes how to adjust the volume. The mute function, which
turns the sound off and on, is also described.
Use [VOL. X / Y] to adjust the audio volume.
VOLUME 20
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar display will automatically disappear in
a few seconds.
• Press [MUTE] to turn off and on the sound.
MUTE 20
• “MUTE” is displayed on the TV screen.
• Press [MUTE] again or [VOL. X / Y] to recover the
original volume.
Switching Each Mode
You can easily switch with the remote control to the DTV (ATSC), TV (NTSC)
and DVD mode or to access an external device when they are connected to
the unit.
Press [SELECT] repeatedly to cycle through analog TV,
digital TV, AUX (external input) and DVD.
Press [SELECT]
[ANALOG MODE]
[DIGITAL MODE]
[AUX (EXTERNAL INPUT MODE)]
[DVD MODE]
• To use the video input jack on the front of the unit,
select “AUX”.
Note:
• When you switch the analog mode to the digital mode, it
may take a while until the digital channel selection is com-
pleted. ”NOW SCANNING” is displayed while switching the
mode.
5
5
P77B1UT.indd 15 2007/09/21 13:21:38