Philips Magnavox CT270MW8 A - Manual (Page 27)

27
EN
WATCHING TV
OPERATING VCR
OPERATING DVD
INTRODUCTION
PREPARATION
INITIAL SETTING
DVD SETTING
INFORMATION
TROUBLESHOOTING
ESPAÑOL
Index Search
This function allows you to index the starting point to make it easy to reach
the point in either fast forward or rewind mode.
• Every time you start recording, an index is marked
automatically. The index mark also works as the start-
ing point of timer recording.
• The index mark will not be recorded if [PAUSE F] is
used during recording.
• The time gap between making the index marks on
the tape should be greater than 1 minute for SP
recording, 2 minutes for LP recording and 3 minutes
for SLP recording.
• In some cases, the index mark at the beginning of
cassette tape cannot be detected.
Example: You are watching program number 4 and want
to fast forward to program number 7. Skip three programs.
pro.1 pro.2 pro.3 pro.4 pro.5 pro.6 pro.7
4 3 2 1 1 2 3
end of
the contents
beginning of
the contents
current playback program
index mark
1
Press [SET-UP] to display the main menu.
2
Use [Cursor K / L] to select “INDEX SEARCH“, then
press [ENTER].
e.g.) digital TV mode
or
– TV/VCR SETUP –
TIMER PROGRAMMING
SETTING CLOCK
CHANNEL SETUP
USER'S SETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
DTV SETUP
B
3
Use [Cursor K / L] to until the number of programs
that you want to skip appears.
or INDEX SEARCH
03
4
Use [Cursor s / B] to let the unit rewind or fast for-
ward to the beginning of desired program.
or
5
When the search is completed, the unit will start play-
back automatically.
Note:
• The numbers of index search can be set up to 20.
• This function is not available during recording.
•
To cancel index search in progress, press [STOP/EJECT C A]
on the unit or [STOP C] on the remote control.
5 Basic Recording & OTR
This function describes how to record to this unit from the programs.
One-touch timer recording (OTR) enables you to start recording for specifi ed
length simply by pressing [REC/OTR .,I] on the unit.
Before you begin:
Insert a cassette tape with its erase-prevention tab in place.
Make sure the cassette has enough remaining tape for the recording.
1
Use [CH. K /L] or [the Number buttons] to select the
channel to be recorded.
or
CH 25
2
Press [SPEED] to select the desired tape speed (SP/ SLP).
(Refer to “Selecting Tape Speeds” on page 24.)
SP
3
Press [REC] to start recording.
REC
4
Press [REC/OTR I] on the unit repeatedly until your
desired length appears on the TV screen. The recording
time will increase by 30 minutes up to 8 hours. Recording
starts immediately when you press [REC/OTR I].
OTR (2:30)
Time(s) Display Recording Length
Once REC basic recording
Twice OTR (0:30) 30 minutes
3 times OTR (1:00) 60 minutes
17 times OTR (8:00) 480 minutes
18 times REC return to the basic recording
5
Press [STOP C] to stop recording.
Note:
• If the recording is paused for more than 5 minutes, the unit will
restart the recording to prevent cassette tape from damage.
• This unit cannot record the contents from the built-in DVD.
• You can only watch the same TV program that is being recorded.
• Even if you press [STANDBY-ONy] during OTR, the unit
continues recording.
• You cannot start OTR with the remote control.
• In the SLP mode, maximum recording time, assuming the
cassette tape starts at the beginning, is 8 hours using T-160
(or 6 hours using T-120).
• If the cassette tape runs out before the end time, the unit will
switch to the stop mode immediately, eject the cassette tape
and turn itself off.
• To show the remaining time of OTR, press [DISPLAY] on
the remote control to display ”OTR” on the TV screen. (It will
show up momentarily then disappear.)
5
P77B1UT.indd 27 2007/09/21 13:21:56