Philips Magnavox MRV700VR - Manual (Page 74)

74 Tape Counter
• You may only set the counter to
zero at one location at a time.
Setting the counter to zero at a
second location will erase the
previous zero setting.
• If you remove the tape, the
counter will reset to zero at the
point at which you last stopped
playback whenever you reinsert
the tape.
Helpful Hints
Follow the steps below to reset a videotape’s counter to zero at a tape
location you want to refer to later.
● Before you begin, make sure the Recorder is in VCR mode. Press VCR so
the VCR light appears on the front of the Recorder.
1 Play, fast forward, or rewind a tape to the location that you
would like to refer to later. Press STOP
C to stop the tape.
2 Press DISPLAY to see the status display.
3 Press CLEAR to reset the counter to zero.
4 Press DISPLAY to remove the status display.
5 When you later want to return to this point on the tape,
press DISPLAY while play is stopped so you can see the
counter on the TV screen. Press PREV/REW
H or
NEXT/FF G.
As the tape rewinds or forwards, watch the counter.When it
approaches or reaches zero, press PLAY B to play the tape.
002
Stereo
SP 0 : 00 : 00
002
Stereo
SP 1 : 23 : 45
1
3
2,4-5
5
E9490UD_EN.qx3 04.8.3 11:55 AM Page 74