Magni Group HDTV - Manual (Page 27)

Chapter 2 25
Using the Remote Control
At this point the remote control is searching for the correct code to
program, so keep pointing it at the component. If, after fi ve seconds, the
component you want to control does not turn off, press and release PLAY
again to tell the remote to search the next set of codes.
Continue pressing and releasing PLAY until the component turns off or until
the all of the component buttons on the remote fl ash 4 times in unison. If
the component has not turned off by the time all the component buttons on
the remote control fl ash 4 times in unison, then the remote cannot control
that particular component.
If the component you want to control does turn off: does does
1. Press and release REVERSE, then wait two seconds. Repeat this step until
the component turns back on.
2. To fi nish, press and hold STOP until the component button you’re trying to
program on the remote control turns off. This saves the code to that button.
Using Direct Entry
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the code list
at the end of this section.
3. On your remote control, press and hold the component button you want to
program.
4. While pressing the component button, enter a code from the code list. If
all of the component buttons fl ash 4 times in unison, then the code you’ve
entered is not the right kind of code for that button (see pages 29-30 to see
which buttons can be programmed to control the component you want).
5. Release the component button, point the remote at the component and
then press ON•OFF to see if the component responds to the remote control
commands. If it doesn’t, try press ing the component button and then
ON•OFF (or other buttons on the remote) again.
6. If you get no response, repeat these steps using the next code listed
for your brand, until the component responds to the remote control
commands.
How to Use the Remote After You’ve
Programmed It
Once the remote has been programmed successfully, you are ready to use it to
operate your components.
To Operate the Component:
1. Press the appropriate component button (DVD, TV, VCR, SAT•CABLE,
AUDIO, AUX•HD) to set the remote to control the component.
2. Press ON•OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.
Notes: T
.
I ,
. Y
( . ., VCR,
VCR VCR .)
Important
Y
.
L ’ Z DVD . T
DVD , :
P DVD -
Z DVD
C .
R DVD . P ON OFF
DVD . I ’ , -
,
Z DVD .
Component Buttons
TV ON•OFF
AUX•HD DVD SAT•CABLE SA SA
VCR
AUDIO
ON•OFF