Motorola HC12 - Manual (Page 50)

User’s Manual MCUez HC12 Assembler
50 Graphical User Interface MOTOROLA
Graphical User Interface
• Save on exit — If this option is set, the assembler will save the
configuration on exit. No prompt will appear to confirm this operation.
If this option is not set, the assembler will ignore any changes.
NOTE: Almost all settings are stored in the configuration file. Exceptions are the
recently used configuration list and all settings in this dialog. These settings are
stored in the assembler section of the mcutools.ini file.
Assembler configurations can coexist in the same file used for the project
configuration (defined by the shell application) along with other MCUez tool
specifications. When an editor is configured by the shell, the assembler can
read this information from the project file, if present. The project configuration
file created by the shell is named project.ini. Therefore, this filename is also
suggested (but not mandatory) to the assembler.
2.4.6.3 Assembler Menu
Table 2-2 depicts the Assembler menu that allows customization of the
assembler and setting or resetting of assembler options.
2.4.7 View Menu
This menu enables customization of the assembler window. For instance,
whether the status bar or toolbar will be displayed or hidden can be defined. The
user also can define the font used in the window or clear the window.
• Choose View|Tool Bar to switch on/off the assembler window toolbar.
• Choose View|Status Bar to switch on/off the assembler window status
bar.
• Choose View|Log ... to customize the output in the assembler window
content area.
Table 2-2. Assembler Menu
Item Description
Options
Allows defining of the options to be activated when assembling
an input file