Motorola AP-51XX - Manual (Page 245)

Configuring Access Point Security 6-27
9. Click the Apply button to save any changes made within this New Security Policy screen.
10. Click the Cancel button to undo any changes made within the WPA2/CCMP Settings field
and return to the WLAN screen. This reverts all settings to the last saved configuration.
6.10 Configuring Firewall Settings
The access point's firewall is a set of related programs located in the gateway on the WAN side of
the access point. The firewall uses a collection of filters to screen information packets for known
types of system attacks. Some of the access point's filters are continuously enabled, others are
configurable.
Use the access point’s Firewall screen to enable or disable the configurable firewall filters. Enable
each filter for maximum security. Disable a filter if the corresponding attack does not seem a threat
in order to reduce processor overhead. Use the WLAN Security screens (WEP, Kerberos etc.) as
required for setting user authentication and data encryption parameters.
To configure the access point firewall settings:
1. Select Network Configuration -> Firewall from the access point menu tree.
NOTE PMK key caching is enabled internally by default when 802.1x EAP
authentication is enabled.