2 configuring ldap authentication, Configuring ldap authentication -67 – Motorola AP-51XX User Manual
Page 285
Configuring Access Point Security
6-67
4.
Use the
Radius Client Authentication
table to configure multiple shared secrets based
on the subnet or host attempting to authenticate with the Radius server. Use the
Add
button
to add entries to the list. Modify the following information as needed within the table.
5.
Click
Apply
to save any changes to the Radius Server screen. Navigating away from the
screen without clicking Apply results in all changes to the screen being lost.
6.
Click
Undo Changes
(if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on the Radius Server screen to the last saved configuration.
7.
Click
Logout
to securely exit the Access Point applet. A prompt displays confirming the
logout before the applet is closed.
6.14.2 Configuring LDAP Authentication
When the Radius Data Source is set to use an external LDAP server (see
LDAP
screen is used to configure the properties of the external LDAP server.
To configure the LDAP server:
1.
Select
System Configuration
->
User Authentication
->
RADIUS Server
->
LDAP
from
the menu tree.
WARNING! If you have imported a Server or CA certificate, the certificate will not
be saved when updating the access point’s firmware. Export your
certificates before upgrading the access point’s firmware. From the
access point CLI, use the
admin(system.cmgr)> expcert
command to
export the certificate to a secure location.
Subnet/Host
Defines the IP address of the subnet or host that will be
authenticating with the Radius server. If a WLAN has been created
to support mesh networking, then enter the IP address of mesh
client bridge in order for the MU to authenticate with a base bridge.
Netmask
Defines the netmask (subnet mask) of the subnet or host
authenticating with the Radius server.
Shared Secret
Click the Passwords button and set a shared secret used for each
host or subnet authenticating against the RADIUS server. The
shared secret can be up to 7 characters in length.