Motorola P930 - Manual (Page 10)

How Your Timeport P930 Two-Way Pager Works 13
To recharge the battery without removing it from
the pager:
1. Insert the transformer’s round connector into the connector on
the back of the charger.
2. Insert the transformer’s two-pronged plug into any standard
120 Vac power supply outlet.
3. Hold the pager face up over the charger.
4. Position the pager with the Motorola logo on the same side as
the charger’s red and green LED indicators.
TIP Before leaving on a trip, make sure the battery and any
extra batteries are fully charged. All rechargeable batteries
experience self-discharge, meaning that a small amount of
energy discharges everyday as a battery sits on the shelf.
Recharging the batteries to full charge should take an hour
or less per battery.
Recharging can be accomplished by placing your Timeport
P930 Two-Way Pager in the charger or by removing the bat-
tery and placing only the battery in the charger. For opti-
mum performance, use the recommended Motorola charger.
Transformer
Two-pronged Plug
Transformer
Round Connector
14 Timeport P930 User’s Guide
Ä
The battery can be charged separately or while it is in the pager.
The charger is intentionally designed so that you cannot place
both the extra battery and the pager in the charger at the same
time.
5. Press the pager down into the charger until an audible click is
heard. The red LED indicator light means the battery is charg-
ing.
Ä
A flashing red LED indicator means the battery is not making
a good contact. Ensure the pager is properly seated in the
charger.
6. When the green LED indicator lights, the battery is fully
charged. Slide the pager forward to release it from the charger.
7. Remove the round transformer connector from the back of the
charger, then remove the plug from the power supply.
Logo
Indicators