Motorola P930 - Manual (Page 42)

General Safety Instructions 77
General Safety Instructions
Follow these guidelines to ensure the safe use of your Timeport
P930 Two-Way Pager and accessories.
Pager Transmitter Safety
The FAA has regulations concerning the use of electronic devices
aboard aircraft. When boarding an aircraft, set the radio transmit-
ter mode to Off on your Timeport P930 Two-Way Pager to avoid
potential interference with aircraft radio communication or navi-
gation equipment.
In hospital or blasting zones, set the radio transmitter mode to
Receive Only. This prevents potential transmission interference
with sensitive medical equipment or explosives devices.
Battery Safety
• Do not dispose of the rechargeable NiMH battery in fire. Bat-
teries can explode when exposed to fire.
• To prevent injury or burns, do not allow metal objects to con-
tact or short circuit the battery terminals.
• Recharge the Motorola 3.6 V NiMH battery (0186386G01) only
with the recommended Motorola battery charger
(0186388G02). Charging this battery by any other method or
with a product not approved by Motorola may cause damage to
the battery.
• Do not charge batteries other than Motorola’s 3.6 V NiMH bat-
tery (0186386G01) in the Motorola battery charger
(0186388G02). Charging other batteries can cause those bat-
teries to burst or explode, resulting in personal injury or prop-
erty damage.
Battery Charger Safety
• Do not expose the charger to rain or snow.
• Use of an attachment not recommended or sold by Motorola
may result in a risk of fire, electric shock, or injury to persons.
• Make sure the cord is located where it will not be stepped on,
tripped over, pinched, or subjected to damage or stress.
• If you need to use an extension cord, make sure:
—the pins on the plug of the extension cord are the same num-
ber, size, and shape as those on the plug of the charger;
—the extension cord is properly wired and in good electrical
condition; and
—the cord size is 18AWG for lengths up to 100 feet and
16AWG for lengths up to 150 feet.
78 Timeport P930 User’s Guide
• Do not operate the charger with a damaged cord, transformer
block, or prongs; replace them immediately.
• Do not operate the charger if it has been damaged in any way;
take it to a qualified service technician.
• Do not disassemble the charger; if service or repair is required,
call Motorola at 1-800-548-9954. Incorrect reassembly can
result in a risk of electrical shock or fire.
• Maximum ambient temperature around the power supply
must not exceed 40 ° C (104 ° F).
• Keep battery contacts clean. Do not allow dirt or sticky sub-
stances to accumulate on the contacts. If you need to clean the
contacts, unplug the charger to reduce the risk of electrical
shock. Use a slightly dampened cloth to clean the contacts. Let
the contacts dry before plugging the charger into an AC outlet.
Do not immerse in water.
Agency Approvals
The Timeport P930 Two-Way Pager has been approved for use by
the Federal Communications Commissions (FCC) and Underwrit-
ers’ Laboratories, Inc. (UL). The charger/docking station has been
FCC approved and the transformer has been UL approved.
Patent Information
This product is manufactured under one or more Motorola U.S.
Patents. A partial listing of these patents is provided inside the
battery compartment. Other patents covering this product are
pending.