Motorola P930 - Manual (Page 32)

FLEX PC Partner 57
To establish a connection between your pager
and FLEX PC Partner on your PC:
1. Snap your pager into the docking station. For information on
connecting the docking station to your PC, see “ The Infrared
Port” on page 17.
2. On your pager, select from the menu wheel.
3. Select .
4. If this is the first time the FLEX PC Partner application is being
installed on your PC continue to the next section, "Configuring
FLEX PC Partner". Otherwise, see “ Using the PC Partner
Shell” on page 58.
Configuring FLEX PC Partner
The FLEX PC Partner Configuration utility is run immediately
after installing FLEX PC Partner. It tells the FLEX PC Partner
application how your pager will be connecting to your PC. If you
change hardware (e.g., replace the charger with a new type of
charger) reconfigure the FLEX PC Partner application using the
following procedure.
To configure FLEX PC Partner:
1. From your desktop, double-click FLEX PC Partner.
-or-
From the Windows 95 taskbar, click Start, then point to
FLEX PC Partner and click FLEX PC Partner.
2. From the PC Partner Shell, double-click Partner Con-
figuration.
3. From the FLEX PC Partner Configuration dialog box, select the
appropriate serial port.
Ä
If the port selection is not correct, an error message appears
(“ No IR devices found”).
4. In the Adapter list box, select the appropriate adapter.
5. Click OK. If this is not the first time FLEX PC Partner has been
configured to your PC, click Yes to save your choices and close
the FLEX PC Partner Configuration partlet.
58 Timeport P930 User’s Guide
Using the PC Partner Shell
The FLEX PC Partner application consists of individual component
applications accessible from the FLEX PC Partner Shell, known as
partlets. Since each partlet operates independently, they can be
used in any order. Except as noted below, you must establish a
connection between your pager and your PC in order to open a
partlet.
The following partlets are currently available:
• Address Book (does not require connection to pager)
• Memory Usage
• Message Manager (does not require connection to pager)
• Backup Utility
• Restore Utility
• Application Manager
• Partner Configuration
To open the FLEX PC Partner Shell:
From your desktop, double-click FLEX PC Partner.
-or-
From the Windows 95 taskbar, click Start, then point to FLEX PC
Partner and click FLEX PC Partner.
To open a FLEX PC Partner partlet from the
Shell:
1. Double-click the partlet's icon.
2. If the FLEX PC Partner Connect dialog box appears, click
Connect.
TIP Right-clicking an icon also displays a pop-up menu you can
use to open a partlet.