Motorola P930 - Manual (Page 40)

FLEX PC Partner 73
To copy data from your pager to your PC for
backup:
1. Snap your pager into the charger.
2. On your pager, select from the menu wheel,
then select and wait for the Connection Status screen.
3. On your PC, open the FLEX PC Partner Shell, then double-click
Backup Utility.
4. At the initial screen, click Next.
5. At the Select Backup File screen, select a destination for the file
containing the saved information, then click Next.
Ä
A default FLEX PC Partner folder is provided, however, you can
change its filename and location.
6. Click Connect to start the backup.
Ä
File transfer may take several minutes, depending upon how
much data you have on your pager.
7. At the success screen, click OK to close FLEX PC Partner and
drop the connection to your pager.
To restore data to your pager from your PC:
1. Snap your pager into the docking station.
2. On your pager, select from the menu wheel,
then select and wait for the Connection Status screen.
3. On your PC, open the FLEX PC Partner Shell, then double-click
Restore Utility.
4. At the initial screen, click Next.
5. At the Select Backup File screen, select the file containing the
saved information you want to restore to your pager, then click
Next.
Caution! DO NOT use the PC Partner Restore Utility to
migrate your data from your PageWriter 2000 Smart
Pager to your Timeport P930 Two-Way Pager. Use only
the System Maintenance Utility, the PC Partner
Backup Utility, and the instructions on page 21 to
perform this operation.
74 Timeport P930 User’s Guide
6. Click Connect to start the restore.
7. When the confirmation message appears, click OK.
Checking Memory Usage on Your Timeport P930
Two-Way Pager
The FLEX PC Partner Memory Usage partlet enables you to
monitor the allocation of persistent storage on your pager. When
the Memory Usage partlet indicates that the free memory on your
pager is getting low, you can increase the free memory level by
deleting old messages or applications.
Ä
The memory usage levels refer to persistent flash storage (anal-
ogous to the hard drive on your PC) rather than volatile memory
(RAM). The Memory Usage partlet does not monitor RAM.
To check memory usage on your pager:
1. Snap your pager into the charger.
2. On your pager, select from the menu wheel,
then select and wait for the Connection Status screen.
3. On your PC, open the FLEX PC Partner Shell, double-click
Memory Usage.
4. Click Exit.
Uninstalling FLEX PC Partner
1. From the Windows taskbar, click Start, then point to FLEX
PC Partner and click Uninstall FLEX PC Partner.
2. Click Yes at the confirmation screen to delete FLEX PC Partner
and all of its components.
Caution! All data on your pager (saved messages, Address Book
entries, and applications) is deleted and replaced by
the version of the data that was restored from your
PC. This means that if you made changes to your
Address Book on your pager after the last backup to
your PC, you will lose those changes during this
restore.
TIP If you add or delete information from your pager while
Memory Usage is open, click Refresh to update the memory
usage information.