Monster Power HTS 5000 - Manual (Page 12)

6
HOOKUP GUIDE
STEP 1 DBS/Phone Hookup
NOTE:
The PowerCenter is intended for hookup of a single phone line only. A second line will NOT be connected through
the phone line surge protector. You can use the HTS 5000
MKII
as a phone splitter, however. If the OUT 1 outlet is in
use, the “PHONE IN USE – OUT1” LED will light up and the OUT 2 outlet will be disengaged. If the OUT 2 outlet
is in use, the “PHONE IN USE – OUT2” LED will light up and the OUT 1 outlet will be disengaged. This telephone
privacy circuit prevents eavesdropping.
FOR PAY-PER-VIEW DEVICES (SUCH AS DBS)
A) Connect one end of a phone cable into a telephone wall jack. Plug the other end into the HTS 5000
MKII
“IN”
jack (figure 1a).
B) Connect a second phone cable from either the “OUT 1” or “OUT 2” jacks to the Pay-Per-View input on your
DBS receiver (figures 1b and 1c).
FOR STANDARD TELEPHONE LINE PROTECTION (NOT A PAY-PER-VIEW DEVICE)
A) Connect a phone cable from a telephone wall jack to the HTS 5000
MKII
“IN” jack. Connect a second phone
cable from either the “OUT 1” or “OUT 2” jacks to the telephone (figures 1b and 1c).
PHONE
OUT 1 IN
OUT 2
Figure 1a
From telephone
wall jack
Figure 1b
To DBS receiver or telephone
Figure 1
Figure 1c
To DBS receiver or telephone