Monster Power HTS 5000 - Manual (Page 15)

9
STEP 3 Remote AC Control Hookups
NOTE:
This feature allows you to turn on/off your PowerCenter via your A/V receiver or preamplifier. You can’t turn off the
PowerCenter using the front panel OFF button when the NORMAL/REMOTE switch is switched to REMOTE.
A) Plug the Remote AC Control cable’s (included) female end into back of your PowerCenter (see diagram below).
B) Switch the NORMAL/REMOTE switch (located on the back of the PowerCenter) to REMOTE.
C) Press the OFF button to turn off the PowerCenter.
D) Plug the Remote AC Control Cable’s 2-prong male end into a switched AC power outlet on a receiver
or preamplifier. When you turn on your receiver or preamplifier the PowerCenter’s outlets programmed
as “switched on” will be turned on immediately. However, the PowerCenter’s outlets programmed as
”switched on after delay” will be turned on after a delay set by the DELAY TIME switch.
GROUND
IN OUT
IN OUT
IN OUT
CABLE TV
SATELLITE
ANTENNA
PHONE
OUT 1 IN
OUT 2
BREAKER 15A PRESS TO RESET 1800W MAX TOTAL
2 1 3 4 5
REMOTE
NORMAL
NO DELAY DELAY
OUTLET PROGRAMMING SWITCHES
UNSWITCHED SWITCHED DELAY NO DELAY
1
2
3
5
4
DC IN
3~30V
REMOTE
AC IN
110V
0.3A
DC OUT
9~12V
300MA
DELAY
TIME
SWITCH
LONG
(20 seconds) SHORT (6 seconds)
TRIGGER
OUT
SWITCH