Monster Power HTS 5000 - Manual (Page 35)

TROUBLESHOOTING (continued)
Possible Cause #2
You are using the Remote DC Control feature (see page 10) and haven’t plugged a 1/8” mini-plug cable into either
the PowerCenter’s corresponding outlet or the component you wish to activate the Remote DC Control feature.
Possible Solution
• Plug one end of the mini-plug cable into the PowerCenter’s corresponding outlet and the other
end into the component you wish to activate the Remote DC Control feature. Once you turn
on the component, the “TIMED ON” LED should light up after approximately either 6 or 20
seconds, depending on the setting of the DELAY TIME switch. .
Possible Cause #3
The component you wish to use to activate the Remote AC (or DC) Control feature isn’t plugged into a properly
grounded 120V outlet.
Possible Solution
• Plug the component into a properly grounded 120V outlet.
29