Monster Power HTS 5000 - Manual (Page 20)

STEP 8 Video Filter AC Outlet Hookup
Isolated Clean Power v.2.0 Stage 4 Video Filter: Optimized to reduce noise generated by video equipment.
Isolates video components from connected digital, video, analog audio, and high current audio components for
maximum rejection of interference.
NOTE:
You may want to program these outlets to be “unswitched” (see page 7, fig. 2a) because some components perform best
when powered continuously. A VCR, for example, should be plugged into one of these outlets to avoid the hassle of
resetting its clock when power is interrupted. Whether you turn your PowerCenter on or off, any component plugged
into these outlets can receive power continuously as long as your PowerCenter is plugged into a properly grounded
120-volt wall socket and the OUTLET PROGRAMMING SWITCHES for the outlet pair are set to “unswitched”. You can plug
any type of analog video component (e.g., VCR, camcorder) into these two outlets.
A) Attach a Monster Power® ID label to each component’s power cord before you plug it into the appropriate
color-coded PowerCenter outlet.
B) VCR: Plug your VCR’s power cord into the PowerCenter’s corresponding VCR outlet.
C) TV/MONITOR: Plug your TV’s power cord into the corresponding TV/MONITOR outlet.
GROUND
IN OUT
IN OUT
IN OUT
CABLE TV
SATELLITE
ANTENNA
PHONE
OUT 1 IN
OUT 2
BREAKER 15A PRESS TO RESET 1800W MAX TOTAL
2 1 3 4 5
REMOTE
NORMAL
OUTLET PROGRAMMING SWITCHES
UNSWITCHED SWITCHED DELAY NO DELAY
1
2
3
5
4
NO DELAY DELAY DC IN
3~30V
REMOTE
AC IN
110V
0.3A
DC OUT
9~12V
300MA
DELAY
TIME
SWITCH
LONG
(20 seconds) SHORT (6 seconds)
TRIGGER
OUT
SWITCH
14