Microtek MiniLink - Manual (Page 10)

WEM INSTALLATION & OPERATION (cont’d)
B. MOUNT DIRECTIONAL WEM
Mount the WEM with the
included wall/pole mount
bracket and hardware. Connect
the mounting block with ball
adjustment to mounting bracket
with the ¼ - 20 button head
screw. Connect the WEM to the
mounting block using the ¼-20
mounting holes in the WEM.
Position the WEM and point
it in the desired direction
Tighten the jam nut against
the bottom of the WEM case
to lock it in position.
U-Bolts w/
Clamps - 2x
¼ - 20 Lock
Washer – 5x
¼ - 20 Nut – 4x
¼ - 20
Button Head
Screw - 1x
B-2 B-1
Directional WEM
C. MOUNT OMNI-DIRECTIONAL WEM
Mount the WEM with the
included wall/pole mount
bracket and hardware. Connect
the WEM to the wall/pole mount
bracket using the ¼-20 button head
screws and lock washers.
Omni -directional
¼ - 20 Lock
Washer – 2x
¼ - 20 Nut – 4x
U-Bolts w/
Clamps - 2x
¼ - 20 Lock
Washer – 2x
¼ - 20 button
Head Screw – 2x
D. CONFIGURE CABLE
Determine the length of CAT5 cable that will be needed and where the PIM will be located. The
total cable length from the WEM to the Ethernet device cannot exceed 300 feet, however, the
PIM can be located anywhere along the 300 feet of cable. The PIM and power supply are not
weather proof and must be placed indoors or in an environmental enclosure. On the WEM end,
feed the CAT5 cable through the supplied weatherproof connector. Slide the supplied black
cable jacket over the cable. Crimp an RJ45 CAT5 connector on the end of the cable and
configure as a straight-through cable.
- 7 -