Microtek MiniLink - Manual (Page 9)

WES CONNECTION DIAGRAM
The following wiring schemes represent the configurations that have been tested and verified by MicroTek
Electronics based on typical Ethernet wiring solutions. Other wiring configurations could be possible based on
the application. A bench test is recommended to verify the designs below.
A. POINT-TO-POINT SYSTEM
B. MULTI-CONNECT SYSTEM
Note: The Ethernet/IP device connects to the “Ethernet In” RJ45 Ethernet port on the PIM. Depending on the
Ethernet/IP device you are using, a crossover cable may be needed.
WEM INSTALLATION & OPERATION
A. SELECT CHANNEL
Locate and remove the ½ inch diameter plug at the side of the WEM. Select the channel the
system will operate on. Each WEM pair or group must share the same channel to communicate
properly. Replace the ½ inch diameter plug after the channel has been selected.
Note: Power to the WEM must be cycled for the WEM to recognize a new channel.
- 6 -
CLIENT
PIM
Power Supply
Straight-through Ethernet
Cable
Transmit Location
HOST
Power Supply
PIM
Straight-through Ethernet
Cable
Receive Location
CLIENT
PIM
Power Supply
Straight-through Ethernet
Cable
CLIENT
PIM
Power Supply
Straight-through Ethernet
Cable
HOST
Power Supply
PIM
Straight-through Ethernet
Cable
Up to 90
Degrees